These are film grades and can be processed easily on conventional blown film lines. J1020FS20 has been blended with necessary additives during manufacture to obtain good surface slip and easy open-ability. J1020FA20 is manufactured without any additive to facilitate adhesion during lamination.

Applications:
Slip grade for Mono & Co-extruded film / Cast film, liner film and non-slip grade for adhesive lamination, hygiene & air bubble film.

Typical Process Conditions:
•Melt Temperature – 160 – 200
•Recommended Blow Up Ratio (BUR): 1.5 – 3.0 (Based on applications, best results achieved with BUR of 2.5 : 1)
•Die Gap –  > 0.8 mm (Based on film thickness and throughput  of the machine)

Regulatory Information
•Meets the requirements stipulated in standard IS: 10146 on “Specification for Polyethylene for safe use in contact with foodstuffs, pharmaceuticals, and drinking water”. It also conforms to IS 16738:2018 “Positive List of Constituents for Polypropylene, Polyethylene and their Copolymers for its Safe Use in Contact with Foodstuffs and Pharmaceuticals”
•The grade and the additives incorporated in it also comply with the FDA: CFR Title 21,177.1520, Olefin polymers.

Storage Recommendations
•Bags should be stored in dry/closed conditions at temperatures below 50°C and protected from UV / direct sunlight.